Fairly new guy to trailering boats here, so excuse the obvious question. Last time I was out, the boat kinda went on the trailer funny at take out. It was a bit off center from the bow roller, and I couldn't get it to jerk over. I cranked it down and went home OK.
Looking at it, the left side bunk is turned up and the boat is on the edge instead of the flat of the bunk board. There is a screw on the bunk bracket that adjusts the angle. It must have not been tightened enough, and came loose, and the board rotated on the edge.
I guess the next time I get the boat in the water, I can turn that bracket and tighten the screw down. Is that it? PS this is a 1756 Alweld mod-V w/50 HP, on an EZ-Loader trailer, a basic model.
THANKS 8)
PS hurry up I wanna go fishin' tomorrow! :lol:
Looking at it, the left side bunk is turned up and the boat is on the edge instead of the flat of the bunk board. There is a screw on the bunk bracket that adjusts the angle. It must have not been tightened enough, and came loose, and the board rotated on the edge.
I guess the next time I get the boat in the water, I can turn that bracket and tighten the screw down. Is that it? PS this is a 1756 Alweld mod-V w/50 HP, on an EZ-Loader trailer, a basic model.
THANKS 8)
PS hurry up I wanna go fishin' tomorrow! :lol: