Recent content by Bx10

If I cant get it the thing right I was going to down size the motor thinking about getting a seadoo n actually putting part of the hull in it so everything is right. I made everything out of aluminum on mine boat. 1/4 throttle almost 30mph Im so close to getting it right I wanna know how it will...

I was going to build a seat n live well onto my center consle think that passenger weight would balance it out. I want to put the gas tank and battery up fornt but my whole front deck it sub framed in with foam pods so I be a pain to cut it open

So pics of the layout of my boat I have the ride plate on it I'm not sure that it's on the right angle cause that a differnt nozzle the motor is 3 cylinder 1000 tigershark motor besides that just the gas tank and a battery in the back

I got spoon built and tested it out I went heavy cavitation not being able to over 5mph to now I got it up to 35mph but I am it's statting to bounce bad after anything more than 20mph I have tryed may trim nozzle each way plus are they supposed to case spray back I'm getting alot spray back...

Tired to get the nicest transition I could but it's kinda hard leaving the center joint in

I have some more time to work on my spoon design and I almost got done

Now if my boat runs and moves at like a 1/8 thottle with out cavaition does that still mean my intake ramp my be a little to much of a angle or is that all air bubbles getting into pump related. It loses all prime when it seems to get ready to get on plain

Kinda hard to see in this picture my jet is level coming out of the boat and I also have a trim nozzle

I made my aluminum intake almost exactly like the fiberglass tigershark intake

I have a 200 miller spool gun welds pretty nice I was definitely going to weld the whole front down and grind it smooth for a nice transition I was thinking about laying a couple 3inch welds down the sides and flex sealing rest of the sides less welding less chance of having leaks also I'm...

I only have one side of intake tac in right now still have a lot of work with smoothing everything out

I was able to some work making my spoon I was wondering what you guys thinks so far if I'm heading in the right direction

I still need to finish the front ramp part of my spoon. Having a hard time finding a perfect way to get a nice gradual front slope along with having being a spoon shape in the front

I started with a 4ft × 2ft .90 thick pice of aluminum made the top a hair wider then my intake 6 1/4in. Then I clamped one side of sheet all the across on a table and bent 3 3/4in to slope my sides down to a angle I was happy with

I have just starred to make a spoon for my jet jon after having some pretty bad cavitation problems. I don't know If my design is the right way of doing it or not