Recent content by cdn_traveller

Ok I will try this tomorrow The gas is 50 to 1 mixed fresh Thanks again

So I replaced the cables. It seems to run a little better but is smoking more than I thought it did. Also I think I should increase the idle speed a bit? Given it stalls or wants to stall when I put in gear? https://youtu.be/N44Qx70dtzI

Well I went out tonight but it was too late to run the outboard. Looks like a bad plug wire though, I tested the wires with my ohmmeter and one was bad. I guess I should have tried that sooner. Will get new wires Monday and try again! Thank you all

I replaced the plugs, coils look ok but I will pull off to be sure. I will try to dig up a Barrell and rig that up.

Hey I have an outboard that I haven't used in about five years. I just redid the carb and tried to adjust things. It runs but doesn't idle well. It pops and shudders and almost stalls Check this https://youtu.be/5P7Ms1uiIlk https://youtu.be/k3a90Kp7HZE Any advice would be appreciated...

From what I can tell, your boat has a max width of 62", mine was about 66" at it's widest spot...so not much different but it is a bit larger! I can only hope that adds the stability your lacks...I will have to get it out on the water this weekend and see what I think. It seems to me that as...

delmonte67 - thanks for your helpful insight :wink: CarlF - It does go pretty well, never measured it though. I know when I used to have a 15 it would go great with just me in it and any more than that it was a crawl. Now I have had myself and 2 other full grown men plus a bunch of...

I have a '90s Sea Nymph 14M and have been debaing adding a flat floor and a casting deck for ages. I just found this site this week so thought I would ask your advice! It is 14'6" long and the gunnels are at it's widest around 66". The base of the boat at the back is around 48" wideTransom is...