Recent content by crabsandbottlecaps

I seen a bunch use pvc to use as rod locker or some type of tubbing was wondering on how the guides on the poles hold up after a while after taking a beating on the water of the bounching up and down i realize there not suppose to move a bunch but they still do any one have a problems . Foam I...

We have pretty much the same set up of boat and iam putting a console in to i was wondering how it rides sitting up front i like that its in the middle seems good spit when trolling and drifting room wise but how does it ride does tge weight of u being up there burry the nose wefish for stripers...

On your tracker . Are the drain holes for the water under the floor small like mine too seems like a leaf or anything small could clog the hole and prevent water from getting back to the bilge pump

Looking at sanded pine plywood Going to coat in spar then vinyl Good idea or wood to soft for decking and box covers

Ya I seen a lot of people use these lights but not sure how there connecting them and what there doing with the converter box... how did u run yours ?

How did u lay the foam board down did u use anything so it would stick and not move

I would most of it lays on the very bottom or on the aluminum it self but u don't have to replace you can leave it out completely but it is there in case of capsizing reasons

U might want to take the foam out of the boat too I just did mine. It looks fine and dry on top but once u get half way threw it most likely it's soaked and water logged my hole boat had 633 lbs of wet foam in it..

Looking to make a console out of aluminum Has anybody made one and have pics

Md do u get at home depot or Lowes And x wood same ?

Putting new floor and deck Down but don't want to use marine plywood what are some other options I can do I am going to wrap wood with vinyl cover like u see at the bass pro shop can I use a birch pressure treated plywood finish it with some type of sealer then vinyl it any good input would help

A lot of people are down with using a wire brush and a drill but I don't no something about aluminum and rivets and a drill with wire spinning has me worrying I like to spray paint stripper and wash off or sand off with a palm sander then clean up with acetone

Copy the img link

Copy the link from photo bucket and just paste it in it will look like a long Web address but it will show up