Recent content by Fatdad5

this is probably a silly question but here it goes.. I picked up 24 volt johnson 56lb food controlled trolling motor for next to nothing.. but have already bought a 2 bank charger and 2 batteries to use my transom mount 47lb motorguide .. dont have the extra cash to buy an extra battery. is...

Can't get pics to load it's a 1968 Starcraft sea farer? Not sure on the spelling sorry

I bought a 68 Starcraft that appears to be a deep vee? They had some rigged up garbage for bunks that I don't want to reuse... Could someone please post a pic of what the bunk set up is supposed to look like?? Thanks in advance for any help.

Very nice boat.. Did you notice the boat being any weaker after you removed the bench? I want to remove mine also and put in a low floor..

Good looking boat!!

Is it possible to use a foot controlled trolling motor on the front of a 14 ft v without a deck?just going to have a floor.. I'm way to big to be up on a raised deck lol

I guess I'll buy one and just leave it in, can't afford to buy a new one .

Yea , just really wanted to know if anyone had done it this way vs tying the side into the floor.

Hello, I have a question and I know the answer probably depends on the boat. I don't have a boat yet but am trying to build it in my head and on paper . I want a 14ft v bottom.. I want to remove the middle bench.. My question is can you run a brace down the side of the boat and attach it to the...

If you need any parts , I should have what ya need.. Just give me a yell.. I'm a Abu junkie lol

That looks great!!! Awsome job!!

I have a 76 evinrude 25 hp that has not been started on three or four years I know i am looking at a carb rebuild and a water impeller Replaced the fuel lines and tried to start it.. No fire.. Am I rite that it has points?? I would really like to get her Goin .. It has. Elec start all That...

Yea, that's it . I just love that layout. Thanks For the pics to cool!!!

I am new here and my first boat I bought Was eat up with corrosion and could not Get a title. But I did rebuild the trailer before I figured that out.. So I have a good trailer to start with lol.. My question is would it be possible to build A flat bottom or semi v set up like a tracker...

I just stripped my trailer down primed and painted it. Went to check and repack the bearings. One of the axle stubs has a big gouge in it and the inner Bearing was stuck. Problem is it is a 3/4 axle stub. Must be pretty old . Any ideal if I can get one ? Or bearings?? I hate to replace the axle...