Recent content by JonBoat

Thanks guys .. Doesn't look like there is a part for the seat only the needle valve. I will try replaceing the float. Let everyone know the results once I get some parts...

Thanks for the advice. I have replaced the needle valve, but will give it another look and make sure the shuts off. Can the seat be replaced?

Thanks crazymname2. I should have listed that I have changed fuel filter, etc. Probably ran 30 gallons of fuel through the motor. Also the timing is 6 degrees BTDC at idle. I have exhausted every avenue I know to take with the fuel. The motor was previously owned and I can tell the carb had been...

I have 1998 25 HP Mercury that is flooding. Rebuilt carb, lowered float to the point it would not even run, Idle screw is all the way in. Raws gas comes out in the water. I purchased it used and it has been that way since I purchased. Checked compression 110# on top, 115# on the bottom. Runs...