Recent content by jwheelfan03

I've been looking for a welded Jon for quite sometime that has a lot of room but it seems most new ones have the long bench seat in the back. I found a couple that would work great for my project but I have no clue what make or model they are. I found the pictures browsing the inter-web. Can...

Thanks!

So I am going to put a diamond plate floor in my boat. My question is, do I need to put flotation under it first? I am worried that water will get down in there, and the flotation will not let it drain to the back? I was just going to put it right on top of the metal stringers, so there's not...

16' and about 6 foot wide. I'm trying to make a good catfish boat, so I found the widest/deepest I could find, that didnt cost and arm and a leg... Thanks

1977 sea nymph. I have only found 1 other like it in the inter web. Here is a picture of the one I found...I was thinkin the same thing about just drilling a hole. Seems like a odd design.

I want to put a floor in my boat but here is the problem: It doesn't have the grooves(strakes) that run down the boat floor to empty water into the transom area. It just has the stringers that run across each section. Water just sits in there and will not drain because of not having those...

Bought my first boat to build. Got the widest, deepest, most reasonable priced boat I could find. My problem is, I dont know where to even start! I want a floor, small casting areas in the front and back. No livewells. Ive been reading a ton of posts on floors, but no one actually says what...