Recent content by Luedy22

Hello, just got a new seaark tunnel hull tiller. Decided to mount a sandec tachometer/hour meter on and found that with a 15pitch prop I was only turning 4900 to 5100 rpms. Mercury says they recommend between 5500 and 6000. So I dropped the pitch to a 13 pitch and it is now reading only 3500...

Picked it up 2 weeks ago. Mounted the trolling motor and turf myself.

4 blade is to compensate for the air that is introduced into the water since it is going through the tunnel and not below the boat in the undisturbed part of the water. At least that is what I have gotten out of the little bit of research so far.

Hello, I just purchased a new rig. 1660 seaark mvt with 18 gallon bow fuel tank. I am putting on a 50 horse Mercury command thrust with an Atlas micro hydrolic jack plate. Question I have is where do I begin on the prop I put on it. Everything I have read says to put a 4 blade with a lot of cup...

How has the boat been treating you? I am getting the same boat in March. Hydro jack as well. What pitch and 3 or 4 blade prop are you running for the tunnel? I'm putting a merc 50 command thrust on mine but am at a loss in where I need to start for the prop. Any recommendations are greatly...