Im panting the entire hull of a Valco 14. Useing Aluma hawk paint, everything I have read says it goes on pretty thick. Will a quart cover it? I plan to brush/roll it on...
So i picked up a 1978 Valco 14" it is rated for a 20HP motor and the transom is 15". I am looking at a new 9.9 probably Tohatsu. That motor weighs 95lbs. Am i going to be ok with that weight? The boat will be used both lake and inland salt water.
Thanks
Pardon the dumb question, but.... i have an older Valco U14. The drain plug hole is non-threaded, just under an inch 0.92". Should i buy a 1" or 7/8" plug?
Thanks
I will start by saying I don't know crap about boat motors... So I have a couple questions.
I picked up 14' aluminum boat for my son to fish on, it came with a 1977 Gamefisher 9.9 217/58622-0. I was told it was only used a few times and has been sitting for 30 plus years. It is very clean and...