Recent content by Sarkan

Can I get one for my 1989 Johnson 9.9? I am also looking for the owners manual to help me with figuring out this mixture knob and my idle issue.

Can someone help point out to me where the idle screw is at on these things? Also, how many full turns out on that mixture screw? I counted about 3 and 1/2 full turns from the stopping point after turning it clockwise. I seriously need the owners manual for this thing.

Great Job! =D> Man! I would to do that to my Lund WC14. Can you share some details or plans with us? First of all, how much did it cost to do all this? What ever it was it looks worth it.

It pisses water just fine. that was the first thing i checked when i bought it.

Okay I tried moving the air/fuel mixture around during idleing and it didn't make a difference. When in idle the motor slows down until is goes out. So I end up pull starting and quickly putting it in gear so I can throttle away. The knob on the end of my throttle body and just behind my kill...

Please post a pic through out your project. Looking to do the same with mine.

Curious. Why would you need a massive bilge pump anyways for a small boat? You taking on 20 footers?

Thanks, I'll try to test that out. Do you think I should do it with earmuffs or actually in the water? Yes, brand new tank and hose so no worries there. I also have some knob at the end of my throttle handle, right behind the kill switch. I don't know what that does either. I thought that may...

I have a Johnson 9.9 on my 14ft Lund WC-14 and been having a problem with maintaining a good idle speed. What is confusing it the Rich/Lean knob and where to set it. I've been looking for the owner's/operator's manual for it with no luck and can't seem to figure out how to use this knob and...

Night fishing can produce some biggies if you are willing to put up with the bugs and not being able to see where you are casting. Top water baits like buzzbaits and poppers get them everytime.

Nice one. =D>

I know they usually repair with epoxy. I had a pin hole in my hull and it was repair with a clear strong epoxy.