I'm also thinking of using the oar holder but does anyone know what kind of screws or bolt are design for this track system, I have already lost a fishing pole because my oar holder popped out of the trac
I know it's been a while but what do you guys suggest for installing the pvc pipe to the side of the boat? I have seen the galvanized bracket at home depot but it's not going to work unless I drill to the outside of the boat. I need to find a way to attach it underneath the track with something...
Anybody knows how hard it is to install a tiller handle on the new 60/40HP mercury jet outboard. I got a price quote of $825 plus $400 install fee. The installation fee sounds a little steep in my opinion.
Does anybody think that the 90/65 4 stroke mercury be too heavy on the transom for my mv1650 alumacraft all welded (book say boat weight 470 lbs)? I'm just afraid the boat will sit too low in the rear and not draft as shallow with that outboard compared to the 60/40 mercury 4 stroke. I know the...
I plan on fishing mostly with just 3 total in the boats. But since you said the 90/65 were so thirsty, I think i made up my mind and just gonna go with the Merc.
I like the reliability of the 4 stroke but don't really like the weight on them compared to the 2 stroke. That's why I was thinking if the Yamaha 90/60 2 stroke weight about the same then I may as well go with it. But again, I would have no warranty on this older engine. But my ultimate goal is...
It's not bad with the speed u getting on that alweld. I'm just hoping it does about the same speed as yours with the 60/40 merc. But can't tell until it is on.