Recent content by STEELRZAHOLIC

Has anyone seen or have rhino linned the inside of their boat to seal all rivets and leaks. I dont know if this will add to much weight to the boat or will it help the bouancy. If anyone can help I would greatly appreciate it before I start this project and spend the money rhino linning the...

Well I have discovered that it is a Otters Craft boat made out of Orgeon USA. I still cannot figure any year from which it was made. The Number is OTCP1022097243. From what a few sites tell me, the last numbers is the year from which it was made. I do not see this aluminum boat being...

My number was stamped at least 3 times on the back of the boats transom. I found the HIN on the inside of the transom at the top and bottom. And also on the top aluminum flange on the transom right on top where the motor sets.

I have a 16ft aluminum V-hull boat with a Johnson SeaHorse 10hp Motor(QD-13(1951-52)). I have not yet found a website that can help identify the Year, Make, and Model of this boat. I have found the boat's HIN(Hull Identification Number) on the back of the boat. If anyone can help me get this...