Recent content by thetinman

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    Sea Ark 1652 Build

    There are not a lot of good things said on this board about Cabelas tuff coat product on this forum. A lot of people have problems with it peeling. That said, I'm guessing it would wear quickly against the aluminum until the wood was in direct contact. I would bet this would happen with most of...
  2. T

    Jon boat vs V hull

    The beam is not the width. The 1232 has a width of 32" and it is not going to be ideal for the applicaiton you are looking to use it for. Simply, it's too unstable and has a low carring capacity and you will be taking a bath if you plan on standing for long periods in a 1232. If it is in your...
  3. T

    SeaArk SuperJon 1872MV Tunnel Remodel (All Pics on Pg1)

    great build. excited to see the finished product.
  4. T

    Any duck boats?

    I installed a 12v plug for charging cell phones and using spot lights. I also installed 'docking' lights on the front for increased visibility (check state laws). Keep the hunting boat as light and clutter free as possible. I've hunted for many years and do not have any positive experience with...
  5. T

    12v plug wiring question

    thank you soo much. thats what i needed.
  6. T

    12v plug wiring question

    cell phone charger and 1,000,000 candlepower spotlight. If it matters, the 12v outlet will be about 4 feet from the power box. thanks for helping
  7. T

    12v plug wiring question

    I'm stuck in the middle of this project and need some advise. I'm installing a 12v plug in my jon and need to know if 18 guage marine wire is thick enough to run from the control panel to the 12v plug. If so, what size inline fuse should I use? Thanks, Mark
  8. T

    Best new 25 hp motor on market?

    Hello, I've been lurking for a while and wanted to get the forums input. I have just purchased a new War Eagle 548 21" transom and will be putting a long shaft 25hp tiller on the back. What is the best new motor on the market and your reason why? Thanks, Mark
Top