Recent content by wildcatfan

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. W

    Fish finder troubleshooting

    Both transducers are still there. Only difference is the addition of the battery charger switch. Guess this one will go on hold until after Christma and hunting season. Who knows Santa may just bring replacements. Again thanks for the replies, when / if I getr it figured out I'll post solution.
  2. W

    Fish finder troubleshooting

    Thanks for the response. Units are a Lowrance X71with display mounted in bow and transducer mounted on the trolling motor and an Lowrance X91 with display mounted on the drivers console and transducer mounted inside hull. Both worked mid October. The only change was a battery selector switch was...
  3. W

    Fish finder troubleshooting

    trying to troubleshoot display on two Lowrance fisfinders (X71 and X91). Both were working in Sept, Took boat out Sunday and neither will display bottom, depth contours, markers, fish etc. The displays will show water temp etc and both will display the simulation. Voltage will display and both...
  4. W

    What branch of the Military did you serve in?

    USCG 1980-2006, E1-E7 then warrant retired as a W4. East and west coasts, Caribbean and Gulf coast.
  5. W

    Boat and prop question

    Thanks for the help. Got an email response from Yamaha. correct prop is 13 1/2 x 15 with motor set in 2nd set of holes from the top. G3 does not provide a gauge package except fuel level, for the Gator Jon. Dealer offered it as an option for $450 plus labor but said I shouldn't need it...
  6. W

    Boat and prop question

    Bought a new G3 1860 center console with a 90hp Yamaha 4 stroke. Had the dealer install a stainless steel prop. I'm about halfway through the break-in period. Limited runs at full throttle I'm only getting 33mph by GPS. Dealer installed a SOLAS 13 x 21 prop. I was expecting low 40's, No tach...
  7. W

    Cabela's bunk guide ons

    A friend looked at these several years ago. I ended up building him a set out of 1/4" x 3" flatbar with a cross bar welded at the top to hold a piece of carpet covered, pressure treated 2x4. Biggest benefit was we were able to custom make them to fit his trailer and boat and since they were made...
  8. W

    2009 Easter Egg Contest

    Thanks. BIG BLUE NATION! Hopefully we'll be back to form soon. Just ordered a G3 1860 cc today. looking forward to delivery
  9. W

    2009 Easter Egg Contest

    With My first post I'll say 32.
Top