Search results

I have an issue that I hope I can get some advice from you all on. Im fairly certain that my transom wood is wet in a few small areas where there are thru-bolts going through. I have noticed over the course of a couple months 3 spots that started out as small pinholes. I drilled out the...

Pulled the gas tank deck off the back of my boat because I noticed a little corrosion in the area and I wanted to take care of it. The picture shows what I found underneath. Im not sure how far up it goes but I don't think its past the center console because there's a hole in the floor there...

I want to replace my carpeted bunks with new treated wood and use properly sized cutting boats on top of that for my bunks. My primary reason being that I fish salt or brackish water 99% of the time and im worried about corrosion. My boat is a 18ft g3 and my biggest worry is that the weight of...

I bought a 2004 G3 1860 CC last summer. While I like the boat, there are several things that I dont like about it. One of them being the floor. When walking around, the floor flexes. Im not a big guy either. Some of the pop rivets that hold the floor in seem loose, and when I let fresh water...

What kind of chop do you think a 18 ft mod v like a g3 or lowe could handle? I dont plan on going out into the bigger water if its windy, but sometimes the weather man is wrong. Any personal experiences that might be insightful?

Looking for aluminum bar, 1.5" thick by 2" wide as long as I can get. Any good online sources or should I stick local? This will be for runners on the bottom of a boat that gets winched over dikes often.

First post here, hope you all can help. I have a 14' jon made by Meyers in Adrian MI. I bought it used several years ago, and its lead a pretty rough life. I let a family member borrow it 3 years ago and they took it off the trailer on land, then tried to winch it back up. Doing this left 2...