Search results

So after months of the engine running flawlessly, I go fishing and while idling through an extremely long idle zone in an area where I've always had problems for some reason, the carb started screwing up. It runs fine then about 30 seconds later gas starts spewing out of the top where that...

Went to a relative of my aunts private pond to fish bass for the first time (or I should say to catch bass for the first time), first 2 casts caught these 2.....23" and 22", 7.5lbs and upper 6lbs on the 2nd one. Caught on a plastic minnow, after I caught these they stopped biting, caught a few...

I am confused as to how these things work. Below is a pic of what my tiller handle looks like (isn't the actual one) and has the little gauge that goes from small to larger bars representing more fuel/speed etc. But I notice once I am about halfway up it is pretty much at full speed and any more...

So I ordered a 9.9hp motor. I found instructional videos for setting up the same motor (smaller hp though) and read through the manual multiple times. As far as I can tell they only say to add engine oil, are motors supposed to come with gear oil already in them?

....Quite ambitious, using either 12 or 15 lb test...I actually didn't realize he was on the line until I reeled it in and casted it back out (Was looking at where I was casting)...see a little fish flying mid air, I was like O well, maybe a big fish will grab him. [-o< The bass are elusive...