Search results

Recently busted transducer on my hummingbird 176i anybody know best place to get a replacement?

Have a 2010 f40 leha efi that idles and runs good but bogs down at wot. Seem to be starving for fuel. Got new gas and changed two of the under hood filters, the paper one in the canister and the inline strainer, neither looked dirty to my eye, and no change in engine performance. I understand...

Would like to put 3/4 pin type seat base on the pod of my xpress 1650. The aluminum looks to be either .100 or .125 , and have no access below. If I had one on the pod the seat would only be used in the low position, no pedestal. Would this hold up with mounted to the pod with screws tapped to...

Looking to mount pin type base in my floor. Most of them I have looked at say they require 2.75 in. clearance underneath. By my measurements I might get 2.5. Does anyone know of any brand that would be compatible with this without shimming some how. Thanks.

Looking to put aluminum floor in my boat. What thickness should I use to install bases for pin mount seat pedastels for fishing.

Have a 2010 yam 4 stroke 40 efi on an older 1650 xpress duck boat factory aluminum prop,12p,not sure of diameter. Gets on plane pretty easy even with 4 people, runs 29 to 31 mph gps. Prop has a few nicks and am looking to replace it. Anybody have experience with similar set up with different...

Test drove a boat yesterday 16 ft. with 2010 Yamaha 40 hp efi. Met owner at ramp and launched, motor started right up idled good so we took off . Planed out nicely ran wide open about a minute, lost power and died, never would start again. Owner had told me boat been sitting almost 2 yrs , told...