Search results

I am trying to figure out the best way to put the foam in the floor between the ribs of my bass tracker. My question is how close do you guys cut the foam to fit. Lets say the shallowest part of the V (closest to the side) is an inch and a half, do you just run an inch and a half thick piece of...

My problem is when I give the boat gas and then pull the throttle back it doesn't throttle down. I thought it might be a broken control cable but I think I have tracked it back to the control box. It looks like the control box will push the cable out but will not pull it back in so the motor...

Guys I have learned tons from this board and I always appreciate your help, I have another question for you. My Throttle is kind of sticking on my motor, If I give it a lot of throttle it will not throttle back down. My question is this, should the motor automatically push the throttle back...

I am going to try to document the process of replacing the shaft in my motorguide. I hit mine pretty hard on a log and bent it up, but I am also going to go to a 36inch shaft too.

Guys I have a motorguide trolling motor I bought to put on my build. Its a 16 foot tracker panfish. It has the longer front deck where the cooler goes if you are familiar with the setup. Anyway I was looking into mounting it today and it looks like because of the extended deck the foot pedal...

Guys I put the lower unit back on and noticed a gap. Should it be there or am I missing a seal there. Thanks again.uploadfromtaptalk1396137117014.jpg

I just replaced my waterpump housing impeller etc. I am not a grade A mechanic or anything, but I ordered a new kit and just replaced the old parts with new parts. It was kind of a hassle getting the impeller key back in etc. Anyway in the process i didn't check the manual or pics I just put the...

Guys I am not sure but I bought this boat and it looks like the po put in a different axel thats a little bigger. You can tell that the wheels dont fit under the fenders. Should I get something to make the fenders work or is there a reason to back down to the smaller axle...

Guys I know from reading other posts I am going to have to cut the welds to get to the transom. I have alreafy talked to a local welder that said he would weld it back on for 50 or 60 bucks. Anyway my question is about the removal. Should I take the angle grinder and use the side of the wheel to...

Guys I was reading some threads about aluminum decking and I came across acouple of different people using outdoor sign material with aluminum sandwhiching a poly material. I thought about it I am a baseball coach and we have tons of the signs laying around from old sponsors that were hanging in...

I just bought the boat I have wanted for a long time a tracker pf16. I am going to have to funish work on my current boat before I get this one fishable but I am excited to get started so I thought I would throw up some pictures and get this thread started. I payed 750 motor runs and steering...

Guys really wanted to just say thanks for all of your help I have been using this site for advice on my latest boat. I really didnt plan on documenting the whole project but I thought I would throw up a couple of pics hey everybody loves pics . And let u guys know the basic things I have done in...