Search results

Don't do anything your grandfather would not approve of in it :lol: Enjoy !

I think the mickey's are getting in the way of the boat work :) Looks like a great time man!! keep practicing and I think you might make it all the way in your tent by the of summer :LOL2:

Thanks Gators5220 Thanks ajmac . I wish I could weld it! I would be done by now! I went the riveted patch route. Kofkorn , nice post on the pamphlet! Great info. I got to get me one of the old school BPS hats and recreate the photo when I'm done :lol: Your thread is one I read over...

Thanks Daryn , the steelflex was like trying to roll on roofing tar :lol: . Says not to use under 60 deg. , and the day I applied it was only about 65 so I'm sure that was part of it . I did as others said and spread it out with a squeegee and then rolled it to smooth , I'm happy with it ...

Sorry for your loss .

man that front deck turned out nice! great job

coming together , looking good man! What oz. carpet did you go with ? I'm ready to order mine , thinking about getting the 20 oz. from them but my hatches were hard to open with the old thin carpet , I may not even be able to close them with new carpet.

The welder that was going to weld up my cracks kept putting me off , so they got some patches also. got all the ribs riveted back in , and the broken keel rivets replaced Hull is Done!!! YEA (except for thru hull stuff) got the steelflex done got the sheet foam in the floor and...

I think it looks good. For sure will stand out from all the other trackers at the lake . Good thing is it is a decal , so if you decide you want to change it later you can just remove and replace :)

the one on the right looks like the one my controls were mounted on edit-- never mind it's a lot smaller and has no taper.

WELDER! I don't need no stinkin welder. I got "ree-vits" 8) Yea wish I had a go to shop close by thanks for the comments guys

great progress! Looking at that console also . Looks like a lot less wasted space. Keep the pics coming so I can figure out how to put mine back together :LOL2:

great price ! congrats man

Thanks Daryn , hopefully it don't turn into a "rivet disaster" :lol: Took a break from the deconstruction to do a little reconstruction. I got the patch panels made. Probably could make them in 10 min. with a break and shear, took me alittle bit longer by hand. wish I had a welder in my...

closed end blind rivet - sealed on the end - used for water tight fastening standard blind rivet - open thru hole - ball on end falls away when used for interior frame construction the standard rivets will work fine . For any thru hull mounting you should use a closed end

I'll give you $50 for the windshield ! :D

Got the three rear ribs out lots of crap to clean I think with this and all of the rivets I have removed I have around 190 holes :shock: should have just put some caulk on the 6 leaky ones and went fishing :LOL2:

Had 6 broken keel rivets total. With them , and the three center ribs removed was able to flex the bottom of the boat enough to look between the keel and hull . Not corroded! Yippie

thanks Skiffing :D yea I think I got the big'ol leaky twin though . Hope it all goes smooth for you !