Search results

I've searched and looked at charts and cannot determine what year this honda motor is. I appreciate any help. On the plate it says BAAJ-160xxxx. Bf8d. Can anyone tell me what year this is? Thanks.

I tend to swap boats and motors around allot and hate drilling holes in transoms. I never drill them and bolt the motor down if it has clamps and is a 25hp or less 2 stroke. I was considering purchasing a power tilt 25hp for a boat that currently has no holes in it. Not knowing how long I may...

Need help. I'm trying to remove the lower unit on a evinrude/Johnson 15 hp long shaft. The motor has that removable extension piece. I loosened the shift shaft clamps but the lower unit won't come free. Is the shifter the only thing holding it on? Should I just pull harder? Any help...

I purchased this motor from a friend not running. I cleaned the carbs and rebuilt the fuel pump. One thing I noticed on the fuel pump is that there is a spring and round plate that is pushing against the diaphragm. When I look at the parts diagram, these parts are shown, but they don't appear...

This is on a 50hp tracker Inc outboard. It's attached to the mounting bracket above the tilt pump. There are some wires going to it. What is it and is it necessary? Thanks.

I got a 8 hp mariner and the overfill hole in the lower unit is stripped. Any suggestions? Can I just try and find a rubber plug for it? Thanks.

Hello, I have a 1991 mariner 40hp magnum 4 cylinder twin carb motor. After running it, gas leaks out of the carb. I installed new floats and needle valves and it still leaks. The fuel seems to find its way to the butterfly valve rod, then drips off it. Otherwise, it seems to run done. The...

I recently acquired what I believe is a mariner 1990 8hp. I put it in a tub of water and ran it briefly and shut it off when no water was seen coming out the taletell. So I figured the impeller was bad or a blockage. Does this have a thermostat? I tried blowing in the water outlet tube at...

Thinking about getting a 1648 jon and currently only have a 96 two stroke 9.9 Yamaha. Will this plane out a riveted 1648 with just me and some equipment? Around 250lbs for me and equipment? Thanks.

I purchased a 1448 Jon boat with the factory paint. The sellers kids painted some white blotches all over one side. The paint is rather hard to remove. It barely comes off when scraping with my fingernail. What's the best way to remove the paint without damaging the green paint underneath...

I've got an 80's mercury 9.9 hp two stroke motor that has a little over 90 psi compression in both cylinders. Is this too low to run properly? Is there a minimum? Thanks.

Just wondering if a 4 stroke 9.9 hp motor would plane a 16' aluminum v utlity boat? I had a 15 on and it seemed fine. Weight of boat is around 300 lbs, total weight would be around 700lbs max. Thanks.