Search results

That is awesome information! What are you using as a spacer for your setback? Also, what size engine are you running? Should I be concerned over the boat not planing well?

Has anyone experimented with implementing a compression plate on an outboard to allow it to run higher? I know this may seem like avoiding the problem, and it is to a certain extent, however, I would like to run the prop as high as possible for a shallow draft.

For some more information, I purchased this boat to go along with the motor, not vise versa. I had the motor from a buddy, and a 13ft gheenoe. Well, the motor made the gheenoe fly to say the least, so I got to looking for a larger hull for the motor. I knew I wanted a wide boat that would get on...

The cavitation plate is definitely around 3 inches above the bottom of the hull, it is more difficult to tell in the (bad) picture I took. The hull also has a very small amount of dead-rise, but it does not seem to have as much as the new model. I have heard varying reports on the 15hp with a...

I recently purchased a grizzly 1448. It is not the newest model, and has exposed ribs and a split rear seat. What I did not consider however was the fact that this model has a completely flat transom, unlike the newer model. The boat is in awesome shape, and I hate to have to do anything to it...