Search results

The floor, top of the gun box and front Deck are all getting tough coat in grey. The rest will get a layer of grey paint. The trolling motor is a 55lb with a 54 inch shaft I believe. It works great. It pulls the boat up to 2.8mph.

Not much more to go. Need to tuck a couple wires and grind a couple edges flush. Video of the build so far. https://youtu.be/1P84uU27GoQ

I added 2 braces connecting the center two horizontal braces you are talking about just so that the seat base would be bolted to more than just the aluminum sheet. I used bolts instead of rivets the horizontal braces. I didn't trust that the constant downward pressure wouldn't walk the rivet out.

I've been pretty busy lately and haven't gotten much work done in the boat but I put the new thicker side on the gun box and mounted the radio, speakers and switch panel. Now I'm wiring everything up and when that's done will put the top of the gun box and and start paint prep.

A few threads down my build is posted. Lowe 1648m first build. I had the same issue on my floor. I ended up using a surface mount base with 1/4x20 nutserts and bolts. That way during duck season I can easily unbolt it and have a flush floor.

Put the gun box side on but it will be getting taken off and replaced with 1/8 inch. 1/16 felt too flimsy to me. I'm sure it would be fine since it isn't structural but it made it feel cheap to me. Also going to be mounting marine radio through it with the speakers and the switch panel so I...

Got the front deck surface on and the seat base mounted.

I was just thinking about my sheet metal and was thinking of changing my plan a bit. Rather than running it over all the bracing cutting it to drop down inside the two top pieces and sit on top of the cross braces. That way everything would be nice and level instead of bowing when riveted down...

Put a couple horizontal braces in today. One in the front of the picture isn't riveted in yet. Still needs a bit of cutting to fit just right. Also ordered my 1/8 sheet for the deck

Got some work done on building the bracing for the front deck and gun box. I just need to finish the horizontals on the gun box

Started making the bracing today. Hopefully it will be strong enough. If not I will put some square tubing under to support it better. I also took some better pictures of the trolling motor bracket

It flexed a little bit the first trip I made without the floor in it after removing the bench. It was 3 foot whitecaps that day though. Now that the floor is riveted in it doesn't flex at all.

Sunrise on green bay is one of my favorite things about duck hunting. Wife took a cool picture when I was fishing the walleye run on the river.

Finally remembered to take a picture of the seat I mounted the other day.used rivnuts through the floor then booked the base to it so I can take it out for duck hunting. Had to go with a surface mount since there's only a inch and a half clearance under the floor.

I have foam board under it to deaden noise but there is zero give to it. I was worried about the pedestal seat masking it bend but there was no issues with it at all.

.125 aluminum tread plate

Got up early today and put my center seat in so the passenger doesn't have to sit on a lawn chair. I'll post some pictures later of it. Wife got me a radio for the boat for my birthday so I'll have to figure out where I will mount it. Thinking the side of the gun box once installed.

I removed the center bench on my 1648m and noticed it twisting a lot before I put the floor in. Now with the floor in it is fine. I'm also extending the deck and adding a gun box but havnt gotten to it yet.

Quick built a trolling motor bracket this morning before work so I can use it tomorrow fishing. Sorry for the dark picture and I forgot to turn my phone so I'm sure it will show up Sideways

I ended up selling the motor to fund building the boat I picked up so I guess I don't have to worry about the belt anymore.