Look into an asus eee pad transformer has quard core proccesor best bang for the buck I have the older dual core and itd great so the newer one would be even better
I have been using some aluminum hobart brazing rods from northern tool the past few days when you heat it it dents the boat but its as hard as a rock and as long as theres no cracks in the braze but i was filling in holes not cracks then you should be alright it also takes some time but way...
I also used rustoleum bed liner the roll on kind, not as rough as hurculiner and I think it turned out great, I did the Whole inside of the boat with it, including the walls where poles and stuff couldnt chip it.
Thats good to know, this one is for the big boat I just got, but I mean it has great spark just probably need to clean the carb(am going to anyways) and the spring is broke to retract the pull start but I picked it up for $50 so after I do that hopefully ill have the same luck as you.
Its where a regular boat seat will go, im making it even with the small front deck im putting on it wich will be only 4 inches from the bottom of the front of the boat since its a 1432 it would be very unstable if I went any higher. If you go to arkansasnatives profile to his boat build im doing...
Haha yeah im having the same problem trying to figure out what mine is been doing research all night and you gave me the idea to post it on here, but I thought yours was probably an alumacraft because it has a round rear end.