Search results

This is the hull view

I just bought a Delta (Gregor Marine of Fresno, Ca) LX 680 center console boat that had been sitting for several years. It is powered by a 1988 Johnson 28 Special, which I plan on pulling off and selling. My intent is to convert it to a tiller model and use it in our local rivers and bays for...

Complete 96 SmokerCraft Alaskan bench seat model package with 15HP 2 stroke Merc and galvanized trailer. Picked up at a garage sale for $1500. Came with lots of extras, including a 3/4 top, anchor system, 2 gas tanks, bumpers, nets, etc... The motor runs like a champ and starts on the 3rd or...

I have a 96 SmokerCraft that the middle seat was pulled out of, leaving bare aluminum exposed. I am looking for matching paint that SmokerCraft uses in the interior of their boats. Anybody have a suggestion on a source? Don't need much, maybe one can should do it. Also, I am putting a floor...

I took the locking nut off that is in the picture, soaked it in Corrosion X and it still won't come off. So...? Thanks for any suggestions. Tom

My two metal boats... The big boat is a 05 Hewescraft SeaRunner, with the Extended Transom and hard top. Powered by a Honda 150 and Honda 15 kicker. Full array of primary and back up electronics. We fish this boat as much as 60 miles off shore in the summer for tuna, halibut, salmon and...

Good morning and thanks. I did pull the plug wires and blocked the prop with it in neutral. No cotter pin or star. That nut just won't budge. It isn't showing signs of corrosion either. I will soak it down with some Corrosion X and try it later this afternoon. Thanks again. Tom

I just bought a little SmokerCraft with a 96 Mercury 2 stroke 15 on it. The prop was really scuffed up on the fins and I was going to replace it. I found a brand new prop in the box under the rear seat while cleaning out the boat, but cannot get the nut to spin off the shaft so I can switch it...

Thanks folks! Yes, it has a very small area of dry storage under the bow, which is nice in our rainy climate. The bow davit works well. I would have preferred a "Dierks" brand, as it has the built in rope cleat, but again, I'm on a budget and this will do since it was on the boat. If you...

HI From the Central Oregon Coast. This is the 3rd SmokerCraft I've owned. First one in 87 when my brand new bride and I bought a 84 14' Alaskan. 2nd one in 1998 when we bought a 16' ProAlaskan and now this project boat. Picked this one up a couple of weeks ago at an estate sale for $1500...