TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
12' Klamath full makeover
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="callelk" data-source="post: 368692" data-attributes="member: 15337"><p>Another question for all of you tin boat guys that run transducers on transom saver type mounts. The bottom of my transom is 90 degrees along bottom and then angles to 75 degrees. The 90 degree is tapered as it follows the 6 degree dead rise from +- 2" in the center to 1/2" at each end. What I am trying to do is mount my transducer plate as I have a 2 transducers and a tolling indicator speed paddle wheel that I need to install and adjust. if I install it along the straight edge, it will be 1" to 1/2" above the bottom of the boat and I'm not sure I can lower the transducer or paddle wheel enough. I could be wrong though.</p></blockquote><p></p>
[QUOTE="callelk, post: 368692, member: 15337"] Another question for all of you tin boat guys that run transducers on transom saver type mounts. The bottom of my transom is 90 degrees along bottom and then angles to 75 degrees. The 90 degree is tapered as it follows the 6 degree dead rise from +- 2" in the center to 1/2" at each end. What I am trying to do is mount my transducer plate as I have a 2 transducers and a tolling indicator speed paddle wheel that I need to install and adjust. if I install it along the straight edge, it will be 1" to 1/2" above the bottom of the boat and I'm not sure I can lower the transducer or paddle wheel enough. I could be wrong though. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
12' Klamath full makeover
Top