TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
15 hp evinrude wont stay at full speed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="chrisc54" data-source="post: 313589" data-attributes="member: 10302"><p>Hey everyone, i just finished raising up my transom as too much water was splashing in, but now i am having a problem, the part circled in red in the picture is not getting directly under the water. My motor is still pissing out a good amount of water. But i noticed going ful speed my motor will all the sudden want to slow down a whole bunch, but would still run fine. I was thinking maybe it was starting to overheat going that fast as that part (circled red) is not under water. The motor idles fine, and trolls fine because the circled red part ius under the water until i take off fast...then within 30 seconds full speed wants to go a lot slower.</p><p></p><p>REally need some advice on this and woulod appreciate it</p></blockquote><p></p>
[QUOTE="chrisc54, post: 313589, member: 10302"] Hey everyone, i just finished raising up my transom as too much water was splashing in, but now i am having a problem, the part circled in red in the picture is not getting directly under the water. My motor is still pissing out a good amount of water. But i noticed going ful speed my motor will all the sudden want to slow down a whole bunch, but would still run fine. I was thinking maybe it was starting to overheat going that fast as that part (circled red) is not under water. The motor idles fine, and trolls fine because the circled red part ius under the water until i take off fast...then within 30 seconds full speed wants to go a lot slower. REally need some advice on this and woulod appreciate it [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
15 hp evinrude wont stay at full speed
Top