TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
16ft Sea Nymph V hull project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="hunter00" data-source="post: 417666" data-attributes="member: 3501"><p>As you can see in the following picture's, I have most of the framing done. I ran two pieces of channel aluminum up the main floor. I will use the channel aluminum to drop supports to, for my cross members under the main floor (which are not done yet). The main floor will rest on the angle below the side cabinets and the front and back. The main floor will be 46 inches wide and about 7 feet long.</p></blockquote><p></p>
[QUOTE="hunter00, post: 417666, member: 3501"] As you can see in the following picture's, I have most of the framing done. I ran two pieces of channel aluminum up the main floor. I will use the channel aluminum to drop supports to, for my cross members under the main floor (which are not done yet). The main floor will rest on the angle below the side cabinets and the front and back. The main floor will be 46 inches wide and about 7 feet long. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
16ft Sea Nymph V hull project
Top