TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1964 evinrude lightwin 3 horsepower stalling
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="derekdiruz1" data-source="post: 389968" data-attributes="member: 16032"><p>Totally took the carb apart today, replaced the gasket/oring thing a majig on the high speed jet (?) as it was totally shot and I hadn't noticed it until now. Also pulled out the bolt and screw that are in the fixed jet and cleaned that out well. </p><p></p><p></p><p>All in all, it runs like a top again! Question though, when I put the low speed needle in, do I put that in, do all adjusting to it, then put the packing nut back over it?</p><p></p><p></p><p>Thanks guys!</p></blockquote><p></p>
[QUOTE="derekdiruz1, post: 389968, member: 16032"] Totally took the carb apart today, replaced the gasket/oring thing a majig on the high speed jet (?) as it was totally shot and I hadn't noticed it until now. Also pulled out the bolt and screw that are in the fixed jet and cleaned that out well. All in all, it runs like a top again! Question though, when I put the low speed needle in, do I put that in, do all adjusting to it, then put the packing nut back over it? Thanks guys! [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1964 evinrude lightwin 3 horsepower stalling
Top