TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
1966 MirroCraft 3614 Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="oakchas" data-source="post: 421454" data-attributes="member: 18746"><p>So, I started by vacuuming out the galvanized shavings out of the hull, and make a stick to represent the width of the back deck. </p><p></p><p>It is then that I decide to check the seat pedestal mounts, and realize I need clearance below the deck for the post (I remembered that I bought surface mount pedestal mounts... But I mis-remembered. The JOYS of getting older!).</p><p></p><p>So, I have to raise the aft deck a bit. Only an inch and a half at the very rear, and an inch and a half at the edges.</p><p></p><p>The bottom of the seat pedestal on the rearmost seat will clear the hull fine. And if not, I can mount the reinforcement ply for it above the top surface of the deck.</p></blockquote><p></p>
[QUOTE="oakchas, post: 421454, member: 18746"] So, I started by vacuuming out the galvanized shavings out of the hull, and make a stick to represent the width of the back deck. It is then that I decide to check the seat pedestal mounts, and realize I need clearance below the deck for the post (I remembered that I bought surface mount pedestal mounts... But I mis-remembered. The JOYS of getting older!). So, I have to raise the aft deck a bit. Only an inch and a half at the very rear, and an inch and a half at the edges. The bottom of the seat pedestal on the rearmost seat will clear the hull fine. And if not, I can mount the reinforcement ply for it above the top surface of the deck. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
1966 MirroCraft 3614 Project
Top