TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1968 EVINRUDE FASTWIN 18HP - COLD START PROBLEMS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="samuelh1987" data-source="post: 471098" data-attributes="member: 21854"><p>That's what I was thinking. So basically a fuel delivery problem within the carb. I have the slow speed needle backed out 1 turn. Its will sneeze if you go any further in and stall if it comes out much more than a quarter turn from there. I have 2 packing washers on the needle. would it be wise to add more? The carb is extremely simple, that's why I'm stumped by it. Could a float that's not set right cause a no start but then work once the motor gets going.</p></blockquote><p></p>
[QUOTE="samuelh1987, post: 471098, member: 21854"] That's what I was thinking. So basically a fuel delivery problem within the carb. I have the slow speed needle backed out 1 turn. Its will sneeze if you go any further in and stall if it comes out much more than a quarter turn from there. I have 2 packing washers on the needle. would it be wise to add more? The carb is extremely simple, that's why I'm stumped by it. Could a float that's not set right cause a no start but then work once the motor gets going. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1968 EVINRUDE FASTWIN 18HP - COLD START PROBLEMS
Top