TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1975 Johnson 25 hp carb help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jonmac3569" data-source="post: 219125" data-attributes="member: 6462"><p>Need some help. I rebuilt the carb as recommended above and I just got through replacing the impeller. In the service manual it says after putting in the new impeller, you turn the driveshaft clockwise to position the impeller in the correct direction inside of the impeller housing. after doing this I could still turn the driveshaft by hand. After I screwed down the 3 screws on the impeller housing (see pic) I can not turn the driveshaft. (by hand or with a pair of channel locks) Is this correct? or should it still turn once I tighten down?</p><p></p><p>It also says tighten to "specified torque" but it doesn't say what that is. But even if I barely tighten, I can't turn driveshaft. if I loosen back up, I can turn.</p></blockquote><p></p>
[QUOTE="jonmac3569, post: 219125, member: 6462"] Need some help. I rebuilt the carb as recommended above and I just got through replacing the impeller. In the service manual it says after putting in the new impeller, you turn the driveshaft clockwise to position the impeller in the correct direction inside of the impeller housing. after doing this I could still turn the driveshaft by hand. After I screwed down the 3 screws on the impeller housing (see pic) I can not turn the driveshaft. (by hand or with a pair of channel locks) Is this correct? or should it still turn once I tighten down? It also says tighten to "specified torque" but it doesn't say what that is. But even if I barely tighten, I can't turn driveshaft. if I loosen back up, I can turn. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1975 Johnson 25 hp carb help
Top