TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
1976 Evinrude 40 HP Model Number 40604A VERY hard to start..
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="11B3G" data-source="post: 270830" data-attributes="member: 8989"><p>I did a very detailed cleaning of the carb..wasn't hardly dirty at all... I did not put a kit in it at the moment because I have yet to be able to locate the correct kit... I was under the impression the high speed nozzle that runs from the carb body down into the bowl had a control needle because when I looked over the manual it showed it in the schematic for the carb. Once I determine the correct rebuild kit I will be ordering one.... unfortunately, due to my job in the military, there is no a whole lot of time to mess around with the boat until I take my fishing trip...My brother is coming up this Friday to look at it. I do have a decent working knowledge of fuel systems and engine repair..just not with 2 strokes really, and trying to figure out how to dial in the carburetor is becoming a bit of a challenge as well.. Thank you for all the suggestions, I am open to any and all.</p></blockquote><p></p>
[QUOTE="11B3G, post: 270830, member: 8989"] I did a very detailed cleaning of the carb..wasn't hardly dirty at all... I did not put a kit in it at the moment because I have yet to be able to locate the correct kit... I was under the impression the high speed nozzle that runs from the carb body down into the bowl had a control needle because when I looked over the manual it showed it in the schematic for the carb. Once I determine the correct rebuild kit I will be ordering one.... unfortunately, due to my job in the military, there is no a whole lot of time to mess around with the boat until I take my fishing trip...My brother is coming up this Friday to look at it. I do have a decent working knowledge of fuel systems and engine repair..just not with 2 strokes really, and trying to figure out how to dial in the carburetor is becoming a bit of a challenge as well.. Thank you for all the suggestions, I am open to any and all. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
1976 Evinrude 40 HP Model Number 40604A VERY hard to start..
Top