TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
4-stroke Eska?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ben2go" data-source="post: 106097" data-attributes="member: 751"><p>You need a plate that will bolt to the leg and then bolt the motor on top of that.1/4 inch aluminum plate should work fine.Then you need to couple the engine out put to the lower unit drive shaft.Use a push mower blade coupler and weld it to the LU drive shaft.The shaft may need to be cut down.You only need a slip fit between the engine shaft and the mower blade coupler.Just make sure the entire key is in the coupler when the engine is installed.Use plenty of antiseize on the shaft.</p></blockquote><p></p>
[QUOTE="ben2go, post: 106097, member: 751"] You need a plate that will bolt to the leg and then bolt the motor on top of that.1/4 inch aluminum plate should work fine.Then you need to couple the engine out put to the lower unit drive shaft.Use a push mower blade coupler and weld it to the LU drive shaft.The shaft may need to be cut down.You only need a slip fit between the engine shaft and the mower blade coupler.Just make sure the entire key is in the coupler when the engine is installed.Use plenty of antiseize on the shaft. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
4-stroke Eska?
Top