TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1448MV - Catfish, Casting & Bowfishing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="RiverBottomOutdoors" data-source="post: 157989" data-attributes="member: 3912"><p>Yea...butt seat on the front. Don't do much sitting when I bowfish or cast. Trying to decide on the best non-skid route...don't want some type of rubber product or bedliner that won't hold up...and I want something light. Was thinking about a little sand sprinkled on wet paint...then a top coat of paint over it. Even if it wears off it would be easy to mend. Got any good ideas on the non-skid?</p><p></p><p>Decks not much higher that the factory deck. I measured it when I first started planning it...I want to say 4".</p></blockquote><p></p>
[QUOTE="RiverBottomOutdoors, post: 157989, member: 3912"] Yea...butt seat on the front. Don't do much sitting when I bowfish or cast. Trying to decide on the best non-skid route...don't want some type of rubber product or bedliner that won't hold up...and I want something light. Was thinking about a little sand sprinkled on wet paint...then a top coat of paint over it. Even if it wears off it would be easy to mend. Got any good ideas on the non-skid? Decks not much higher that the factory deck. I measured it when I first started planning it...I want to say 4". [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1448MV - Catfish, Casting & Bowfishing
Top