TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Aluminum Floor Installation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="FuzzyGrub" data-source="post: 257674" data-attributes="member: 3438"><p>I just went through the same process. The flange is raising the foam. I ended up shimming all the ribs vs removing 0.100" from the foam. I also shimmed the middle of the foam, and after recommendation here, cut channels in the foam for some air space and additional space for drainage toward the center. </p><p></p><p>I used 0.040" alum, but if you can work with thicker, probably bettter. See my project link below for some pics.</p></blockquote><p></p>
[QUOTE="FuzzyGrub, post: 257674, member: 3438"] I just went through the same process. The flange is raising the foam. I ended up shimming all the ribs vs removing 0.100" from the foam. I also shimmed the middle of the foam, and after recommendation here, cut channels in the foam for some air space and additional space for drainage toward the center. I used 0.040" alum, but if you can work with thicker, probably bettter. See my project link below for some pics. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Aluminum Floor Installation
Top