TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Aluminum floor thickness reccomendations
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wmk0002" data-source="post: 404880" data-attributes="member: 13975"><p>What is the width going to be and will the floor be purely fastened to the lateral angles? </p><p></p><p>I do aerospace stress analysis and have a program at work I can use to model a section of the floor and get stresses and max deflections. It will act under the assumption that the lateral angles it attaches to are completely rigid and I will have to make an assumption on the load to give it. I would imagine a single 300 lb load distributed over a small area, like 4" x 4" at the very center, would be good enough. I could get results from that and then model in some additional bow/stern angles and see how much it drops.</p></blockquote><p></p>
[QUOTE="wmk0002, post: 404880, member: 13975"] What is the width going to be and will the floor be purely fastened to the lateral angles? I do aerospace stress analysis and have a program at work I can use to model a section of the floor and get stresses and max deflections. It will act under the assumption that the lateral angles it attaches to are completely rigid and I will have to make an assumption on the load to give it. I would imagine a single 300 lb load distributed over a small area, like 4" x 4" at the very center, would be good enough. I could get results from that and then model in some additional bow/stern angles and see how much it drops. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Aluminum floor thickness reccomendations
Top