TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Any one use a smaller floor than the width of your boat ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="overboard" data-source="post: 238827" data-attributes="member: 6547"><p>sort of have the same situation: 1654 tracker. I know they make aluminum sheet that is 5' x 10' x 1/8". there is a place that I know of, here in PA., that sells these, and reasonable. don't know if diamond plate can be bought that wide though, I didn't check on that.</p><p>if I were using the 4' wide pcs. I think I'd just go down the middle, and either rivet or weld pieces onto each side, to fill in the gaps.</p></blockquote><p></p>
[QUOTE="overboard, post: 238827, member: 6547"] sort of have the same situation: 1654 tracker. I know they make aluminum sheet that is 5' x 10' x 1/8". there is a place that I know of, here in PA., that sells these, and reasonable. don't know if diamond plate can be bought that wide though, I didn't check on that. if I were using the 4' wide pcs. I think I'd just go down the middle, and either rivet or weld pieces onto each side, to fill in the gaps. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Any one use a smaller floor than the width of your boat ?
Top