TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
Anybody Ever Had a V17 Tournament Wiring Replaced for Motor?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="driz" data-source="post: 417927" data-attributes="member: 13373"><p>[ATTACH=full]86648[/ATTACH]Oh but I found it :roll: . I kept looking at the schematic I posted before and there is a hot going directly from the battery to the solenoid . Then why not mine. So I start looking at the solenoid and all I see is black. Nice big black and a nice equally big black going to the starter stud for a ground. One has a piece of red tape on it but the casing is BLACK. Of course it goes out of sight down into the loom below. That got me to thinking why........... The other end I finally ran down to the ground terminal on the troller battery. I did it using an ohm meter. That end had a BLUE piece of tape on it. Duhhhhh. [-X </p><p> [-X I found this late this evening so haven't switched up the wiring but I am betting it's the problem. Somebody set me up . Note the pic with the wire up in the air. That's just a few cents worth of spray paint :roll: . Now me or anyone else afterwards is going to mess that up again. Ughhhh, and I opened up a couple hours worth of repairs just to get back where I was before because of that stupidity. The best part is that by the look of it that wire had been that way since they switched out the motor who knows how long ago and it looked like a mechanic did it. [-X</p></blockquote><p></p>
[QUOTE="driz, post: 417927, member: 13373"] [ATTACH type="full" alt="IMG_1190.JPG"]86648._xfImport[/ATTACH]Oh but I found it :roll: . I kept looking at the schematic I posted before and there is a hot going directly from the battery to the solenoid . Then why not mine. So I start looking at the solenoid and all I see is black. Nice big black and a nice equally big black going to the starter stud for a ground. One has a piece of red tape on it but the casing is BLACK. Of course it goes out of sight down into the loom below. That got me to thinking why........... The other end I finally ran down to the ground terminal on the troller battery. I did it using an ohm meter. That end had a BLUE piece of tape on it. Duhhhhh. [-X [-X I found this late this evening so haven't switched up the wiring but I am betting it's the problem. Somebody set me up . Note the pic with the wire up in the air. That's just a few cents worth of spray paint :roll: . Now me or anyone else afterwards is going to mess that up again. Ughhhh, and I opened up a couple hours worth of repairs just to get back where I was before because of that stupidity. The best part is that by the look of it that wire had been that way since they switched out the motor who knows how long ago and it looked like a mechanic did it. [-X [/QUOTE]
Verification
Post reply
Forums
Boats
Electrical
Anybody Ever Had a V17 Tournament Wiring Replaced for Motor?
Top