TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Can't kill engine
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="user 7806" data-source="post: 249063" data-attributes="member: 7806"><p>There is only one terminal on the kill switch so I don't see how you could pass the salmon wire through it. The kill switch goes to ground till you press it then it's open.</p><p></p><p>I'm gettting ready to rewire the motor tomorrow. Normally I would solder the connections together, but I understand that it's better to crimp the splices. Is this correct?</p></blockquote><p></p>
[QUOTE="user 7806, post: 249063, member: 7806"] There is only one terminal on the kill switch so I don't see how you could pass the salmon wire through it. The kill switch goes to ground till you press it then it's open. I'm gettting ready to rewire the motor tomorrow. Normally I would solder the connections together, but I understand that it's better to crimp the splices. Is this correct? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Can't kill engine
Top