TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Cavitation Plate Location
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="blackshear" data-source="post: 462862" data-attributes="member: 24376"><p>I took my boat out for a test run today with the 1” riser. I gained about 100 RPM to approximately 5850 and gained about 0.5 mph to 27.8. I was hoping for a little higher RPM but maybe I will gain a few more by raising it another .50”. The boat didn’t come close to ventilating so I’m wondering if I can go up another .75” instead of the .50”. It is a real pain to get the parts made so I want to get it right the first time.</p></blockquote><p></p>
[QUOTE="blackshear, post: 462862, member: 24376"] I took my boat out for a test run today with the 1” riser. I gained about 100 RPM to approximately 5850 and gained about 0.5 mph to 27.8. I was hoping for a little higher RPM but maybe I will gain a few more by raising it another .50”. The boat didn’t come close to ventilating so I’m wondering if I can go up another .75” instead of the .50”. It is a real pain to get the parts made so I want to get it right the first time. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Cavitation Plate Location
Top