TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Grizzly 1448 wont PLANE HELP!!!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="onthewater102" data-source="post: 420991" data-attributes="member: 13702"><p>^^ That's along the lines of what I was getting at - but the recommendations are all over the place depending on who you talk to.</p><p></p><p>For that sized motor you could just get two random lengths (10"-12") of 3" channel from onlinemetals.com and a random length of 3"x1.25" flat bar and make an offset for ~$40 plus the cost of some hardware at your local hardware store to hold it together. You should have enough material to put a few screw holes in it to play with mounting heights to get it right for your needs.</p><p></p><p>Channel Link:</p><p></p><p>https://www.onlinemetals.com/merchant.cfm?pid=1064&step=4&showunits=inches&id=298&top_cat=60</p><p></p><p>Flat Bar Link:</p><p></p><p>https://www.onlinemetals.com/merchant.cfm?pid=7008&step=4&showunits=inches&id=997&top_cat=60</p><p></p><p>(random lengths >10" are fine for these transom applications & avoid the cut fees that come with precise lengths)</p></blockquote><p></p>
[QUOTE="onthewater102, post: 420991, member: 13702"] ^^ That's along the lines of what I was getting at - but the recommendations are all over the place depending on who you talk to. For that sized motor you could just get two random lengths (10"-12") of 3" channel from onlinemetals.com and a random length of 3"x1.25" flat bar and make an offset for ~$40 plus the cost of some hardware at your local hardware store to hold it together. You should have enough material to put a few screw holes in it to play with mounting heights to get it right for your needs. Channel Link: https://www.onlinemetals.com/merchant.cfm?pid=1064&step=4&showunits=inches&id=298&top_cat=60 Flat Bar Link: https://www.onlinemetals.com/merchant.cfm?pid=7008&step=4&showunits=inches&id=997&top_cat=60 (random lengths >10" are fine for these transom applications & avoid the cut fees that come with precise lengths) [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Grizzly 1448 wont PLANE HELP!!!!!
Top