TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
He Reigns Mon Ark project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="He Reigns" data-source="post: 353380" data-attributes="member: 14103"><p>Got to work right after getting home. Used 1 inch aluminum angle iron to trim out the jet pump housing. Caulked it up good while doing it. Then we installed the motor. My buddy and I picked it up and set on the gunnel changed position to inside the boat and set it on mounts. We had to change some shims around to get the drive shaft perfectly centered for the impeller. Reinstalled the exhaust and started to place fuel and oil tanks in empty areas to see how it was all going to fit. The top of the expansion chamber is exactly even with the top of the gunnels. I managed to get a 48" x 48" piece of aluminum that will become the majority of the back deck. Tomorrow is framing and mounting controls.</p></blockquote><p></p>
[QUOTE="He Reigns, post: 353380, member: 14103"] Got to work right after getting home. Used 1 inch aluminum angle iron to trim out the jet pump housing. Caulked it up good while doing it. Then we installed the motor. My buddy and I picked it up and set on the gunnel changed position to inside the boat and set it on mounts. We had to change some shims around to get the drive shaft perfectly centered for the impeller. Reinstalled the exhaust and started to place fuel and oil tanks in empty areas to see how it was all going to fit. The top of the expansion chamber is exactly even with the top of the gunnels. I managed to get a 48" x 48" piece of aluminum that will become the majority of the back deck. Tomorrow is framing and mounting controls. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
He Reigns Mon Ark project
Top