TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
HELP! Need ideas for transom mount trolling motor platform!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="BassNBob" data-source="post: 55557" data-attributes="member: 630"><p>I would have someone make a bracket 6"W x 8"L x 2" T with four holes in the lower section located on both sides. Slide this bracket over your transom and level it up even with the piece of the left side you were speaking of. Then use the bracket as a template and drill the four holes and install the four bolts that will go through the transom. Tighten the nuts and install your trolling motor.</p><p>If the 2" is not enough then go 2.5" or whatever is acceptable.</p><p>The four holes can be 3/8".</p><p>If your are worried about water use some caulking around the bolts when you install them.</p><p>1/8" material should be plenty.</p></blockquote><p></p>
[QUOTE="BassNBob, post: 55557, member: 630"] I would have someone make a bracket 6"W x 8"L x 2" T with four holes in the lower section located on both sides. Slide this bracket over your transom and level it up even with the piece of the left side you were speaking of. Then use the bracket as a template and drill the four holes and install the four bolts that will go through the transom. Tighten the nuts and install your trolling motor. If the 2" is not enough then go 2.5" or whatever is acceptable. The four holes can be 3/8". If your are worried about water use some caulking around the bolts when you install them. 1/8" material should be plenty. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
HELP! Need ideas for transom mount trolling motor platform!
Top