TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
How are you guys sanding your boats for paint?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bigwave" data-source="post: 249383" data-attributes="member: 7537"><p>I also used zipstrip, I started with aircraft remover, It did not work as good as the zipstrip. My boat had a zinc cromate primer that was very hard to get off....the zipstrip took it right off followed by a good pressure wash. I used a wire wheel to get the stuff off that I missed. I then used 100grit sand paper to rough it up for the primer. JFYI I did not strip the inside and just used self-etching primer right over the old paint....I think I probably could of got away with this on the outside, but I will not know until I paint the outside. I would suggest a test area and see if you like the finish. </p><p></p><p>just my 2cents though</p><p>kevin</p></blockquote><p></p>
[QUOTE="bigwave, post: 249383, member: 7537"] I also used zipstrip, I started with aircraft remover, It did not work as good as the zipstrip. My boat had a zinc cromate primer that was very hard to get off....the zipstrip took it right off followed by a good pressure wash. I used a wire wheel to get the stuff off that I missed. I then used 100grit sand paper to rough it up for the primer. JFYI I did not strip the inside and just used self-etching primer right over the old paint....I think I probably could of got away with this on the outside, but I will not know until I paint the outside. I would suggest a test area and see if you like the finish. just my 2cents though kevin [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
How are you guys sanding your boats for paint?
Top