TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
How to brace a jon boat after bench removal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="PSG-1" data-source="post: 297109" data-attributes="member: 6937"><p>What about using some channel, or square tube, with a piece of flat aluminum stock welded to the bottom? It wouldn't exactly be a 'hat channel' but the flat stock would give you a flange to be able to attach to the boat, and the tube or channel would act as the structural member, where you could tie your floor in to that.</p></blockquote><p></p>
[QUOTE="PSG-1, post: 297109, member: 6937"] What about using some channel, or square tube, with a piece of flat aluminum stock welded to the bottom? It wouldn't exactly be a 'hat channel' but the flat stock would give you a flange to be able to attach to the boat, and the tube or channel would act as the structural member, where you could tie your floor in to that. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
How to brace a jon boat after bench removal
Top