TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
How to replace Mercury manual trim with power
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Callmecaptain" data-source="post: 385665" data-attributes="member: 17992"><p>Would I need to get the entire Mercury power trim assembly if I wanted to convert from manual trim to power trim? Is it possible to just install the electrical stuff and motor? How do people usually go about this?</p><p></p><p>I was considering one of those CMC 130 units but I'm starting to think about not going that route because it would push my outboard further away from my tunnel hull.</p></blockquote><p></p>
[QUOTE="Callmecaptain, post: 385665, member: 17992"] Would I need to get the entire Mercury power trim assembly if I wanted to convert from manual trim to power trim? Is it possible to just install the electrical stuff and motor? How do people usually go about this? I was considering one of those CMC 130 units but I'm starting to think about not going that route because it would push my outboard further away from my tunnel hull. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
How to replace Mercury manual trim with power
Top