TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
hull issues...need help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bigrob" data-source="post: 392930" data-attributes="member: 19592"><p>Rich, one thing i was considering was not just the 5200 but stripping, preparing the hull, filling holes by sticking the tip of the caulk gun into each hole and unloading a ton couple good squeezes of 5200, and then as a final act having approz 3/8" of the k5 polyurea applied to the entire hull. </p><p>I have been doing some research on k5 and am wondering if others have any experience with it. </p><p>here is a mrketing piece on it and their is a guy about an hour away who is a factory licensed applicator</p><p></p><p></p><p>https://www.specialty-products.com/pdf/job-profiles/Job%20Profile%20-%20K5%20-%20Phantom%20Jet%20Boats.pdf</p><p></p><p>thoughts ? experiemces?</p></blockquote><p></p>
[QUOTE="bigrob, post: 392930, member: 19592"] Rich, one thing i was considering was not just the 5200 but stripping, preparing the hull, filling holes by sticking the tip of the caulk gun into each hole and unloading a ton couple good squeezes of 5200, and then as a final act having approz 3/8" of the k5 polyurea applied to the entire hull. I have been doing some research on k5 and am wondering if others have any experience with it. here is a mrketing piece on it and their is a guy about an hour away who is a factory licensed applicator https://www.specialty-products.com/pdf/job-profiles/Job%20Profile%20-%20K5%20-%20Phantom%20Jet%20Boats.pdf thoughts ? experiemces? [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
hull issues...need help
Top