TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
hull issues...need help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="richg99" data-source="post: 393126" data-attributes="member: 4376"><p>I know you are trying, very hard, to keep from pulling the floor deck and having the bottom welded. </p><p></p><p>The simple answer to your question about applying 5200 to fill...and then putting a coating (any coating ) over it is......will the coating in question be guaranteed to remain stuck to 3M5200 for the life of the boat?</p><p></p><p>I will bet that NO manufacturer or applier will give you that assurance. You can also write 3M and ask the same question.</p><p></p><p>I sincerely doubt that 3M5200 will be a safe solution to 100 1/4 inch holes.</p><p></p><p>rich</p></blockquote><p></p>
[QUOTE="richg99, post: 393126, member: 4376"] I know you are trying, very hard, to keep from pulling the floor deck and having the bottom welded. The simple answer to your question about applying 5200 to fill...and then putting a coating (any coating ) over it is......will the coating in question be guaranteed to remain stuck to 3M5200 for the life of the boat? I will bet that NO manufacturer or applier will give you that assurance. You can also write 3M and ask the same question. I sincerely doubt that 3M5200 will be a safe solution to 100 1/4 inch holes. rich [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
hull issues...need help
Top