TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
I bet this has been asked before. But here goes.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="nomowork" data-source="post: 270859" data-attributes="member: 6029"><p>I can handle the manual tilt (trim is semi permanently set with a pin) easily enough on my 15hp four stroke while in the water. </p><p></p><p>I have the CMC hydraulic power lift and trim on my glass boat with a 40hp Mercury. The Mercury already has a hydraulic lift "assist" but it's much easier to just push the toggle switch. I've seen the CMC units on line around $400 and up. Then there's the electrical connections, etc.</p><p></p><p>What size boat?</p></blockquote><p></p>
[QUOTE="nomowork, post: 270859, member: 6029"] I can handle the manual tilt (trim is semi permanently set with a pin) easily enough on my 15hp four stroke while in the water. I have the CMC hydraulic power lift and trim on my glass boat with a 40hp Mercury. The Mercury already has a hydraulic lift "assist" but it's much easier to just push the toggle switch. I've seen the CMC units on line around $400 and up. Then there's the electrical connections, etc. What size boat? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
I bet this has been asked before. But here goes.
Top