TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Jack plate with tilt and trim?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="nccatfisher" data-source="post: 446986" data-attributes="member: 10811"><p>I'll warn you ahead of time you have two choices if you go with CMC and have a Yamaha. You will have to make an adapter plate to go between the motor and the CMC unit or go with the bigger 130 unit from CMC. The Yamaha 25 bolt pattern is wider than most small outboards and will not fit the small CMC units. I go the adapter route. I have put several on.</p></blockquote><p></p>
[QUOTE="nccatfisher, post: 446986, member: 10811"] I'll warn you ahead of time you have two choices if you go with CMC and have a Yamaha. You will have to make an adapter plate to go between the motor and the CMC unit or go with the bigger 130 unit from CMC. The Yamaha 25 bolt pattern is wider than most small outboards and will not fit the small CMC units. I go the adapter route. I have put several on. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Jack plate with tilt and trim?
Top